| Re: I am trying to understand the Effects of SES 15,22,32 |
Subject: Re: I am trying to understand the Effects of SES 15,22,32 by dry on 2009/6/15 19:45:16 Good News worked on the Elimination of SES 15/32/22 Codes this weekend and all are gone! I reset the TPI Idle by the book also reset the IAC and Tested the CTS per Manual and it failed so i replaced the CTS as well. Cleared computer of codes and started Vette and let it idle etc for about 15 minutes all seemed well and all codes are now gone. So i took it for a casual 10 minute drive all seemed well. Then i lit it up a few times on the way home and it ran like a scalded A$$ Ape upon pulling into my neighborhood it seemed to be running rough so i let it set in the drive way and idle for a few minutes and it was still running pretty rough, so i turned it off and checked for codes still no codes all are still gone just flashes a 12. SES Light is only lit when key is turned on and then goes out immediately when started. So i start vette back up again its still running rough i let it idle for about 10 minutes and it finally cleared up and smoothed out to where it was fine again, drove it a mile or so down the road and was fine, but if i kicked it in the A$$ a few times it would run through all the gears strong but when i would bring back down to normal cruise it would start running rough again and would smooth out after about a 10 minute idle? Also the fuel reg/ dizzy cap /rotor bug/plat plugs and bosch III's are brand new. Does this seem like a Fuel flow from tank or a Heat soak distributor module problem, any ideas appreciated!! |
